Re: Dustributor removal & installation

Posted by JWL On 2020/7/26 11:58:15

Why do you want to replace the distributor?

I would clean and oil, and adjust the points on the spare before installing. Note the rotor and distributor positions before removing the and install the spare in the same positions. It is possible to get these distributors 180 deg. off. Also, there should be a seal at the base of the distributor. Make sure the spare goes in with one. If you are replacing an Auto Lite with a Delco, then the cap will need to be changed. A one for one swap of the wires into the spare's cap will help insure the correct order. Connect the high tension and primary leads and the vacuum line and you should be all set to start the engine and set the timing.

What did I miss?

Oh yes, make sure the grease cup is reloaded with fresh grease.