Re: Wheel cylinders for 21-23 Custom Eight models

Posted by HH56 On 2020/8/4 8:22:52

Upgrading to 23rd standards is probably not a bad idea anyway and rethreading is a good solution for the experienced mechanic with the proper tools.

For the average driveway DIY mechanic who just does bolt ins, I wonder if there would be enough room a standard 3/8 to 7/16 adapter as used on the rear cylinders could also be used on the front cylinders and still have adequate hose clearance at full turn? I believe the adapters would add approx 1/2 to 5/8 inches at the connection.

It would start to be getting into the realm of mods and probably be more expensive than just buying the $40-45 vendor supplied cylinder but maybe a good plan would be to upgrade and install new hoses too as another safety measure. If there is not enough adapter clearance for turns perhaps a later 3/8 hose could also be substituted and an adapter used at the top end of the hose.