Re: Horn not honking

Posted by Wesley Boyer on 2020/9/2 7:54:03
I try not to take anything for granted. Wires do break and I would rather be safe then sorry.
The next thing you can check is the Ring (Contact Plate) to the Upper Spring Support. Using an Ohm Meter the Ring (Contact Plate) should rock up and down (One side should go down while the other side stays up.). When it goes down the meter should show zero ohms from open.
Wes

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=226193