Re: 1951 Exhaust support #426241

Posted by HH56 On 2020/9/3 10:10:47

I was thinking about the visible tab on the 53 exhaust pipe as to whether it is a single tab welded on or a wrap around. Unfortunately the photo is small so there is not much detail and the unraveled duct hose hides enough that you cannot see if there is possibly another tab with a hole behind the loops.

If there is another tab that would make it a wrap around sort of clamp where both halves bolt together with the support in the middle or side. A wrap around clamp is sort of what the 46-50 models used and those clamps could be a pain to spread enough get on the pipe and then pulled together again and held so a nut could thread onto the bolt.