Re: Noisy Lifters even though they are new

Posted by JeromeSolberg on 2021/11/11 21:19:41
Yes I have the special gauge, I got it from Pacific Northwest Packards (club project). I measured the clearance on all the valves, there were a few that were near 0.030, but all were in the range .030 to .070, which is spec. That was done cold.

But I'm going to measure them again. When I replaced the two lifters with the two spares the clearance was between .040 and .060.

But yes, good to check again. Thanks.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=238590