Re: Screws behind bell housing?
Posted by Bob J On 2023/6/7 10:20:11
I found the bag of hardware for the block. There are two square .320" drive 3/8 pipe thread plugs .430 deep, one straight slot drive 3/8 pipe thread plug .482" deep and one frost plug .592" diameter x .385" deep. I see McMaster-Carr carries the square drive one and see no reason that 3 of those cannot be used in place of the one slot drive. Hope this helps you replace the hardware if you decide to drill them out.
Bob J.
Attach file:
plugs.JPG (164.05 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=257776