Re: Help with carburetor
Posted by Fish'n Jim On 2023/12/3 22:17:35
If it's still stalling out, need to check if fuel or ignition problem. Check for spark as it dies. Timing light or spark tester.
See attachment on adjusting. Anti-percolation circuit on these.
I suspect it wasn't done right but can't tell over the internet. If they don't bench or engine test, and spec sheet can't tell if it's right when it comes back. A good shop will test.
'49 is WDG and I rebuilt myself and it would idle at 400 rpm for as long as I let it run - no heat-up, no stall out. Engine compartment wiring & ignition was fresh.
Attach file:
46-48_Repair_Tuneup_Manual.pdf Size: 6,947.54 KB; Hits: 29
See attachment on adjusting. Anti-percolation circuit on these.
I suspect it wasn't done right but can't tell over the internet. If they don't bench or engine test, and spec sheet can't tell if it's right when it comes back. A good shop will test.
'49 is WDG and I rebuilt myself and it would idle at 400 rpm for as long as I let it run - no heat-up, no stall out. Engine compartment wiring & ignition was fresh.
Attach file:
46-48_Repair_Tuneup_Manual.pdf Size: 6,947.54 KB; Hits: 29This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=265412