Re: Lights in the head
Posted by HH56 On 2023/12/10 21:22:44
They should. I couldn't find specs on the Wagner bulb but here is another brand and I suspect they would be close. At 50 watts Halogens have a slightly higher wattage than the original incandescents at 45 watts. Each Halogen bulb pulls close to 8 amps on hi beam while the stock bulb pulls just over 7 amps. If the circuit breaker has not lost much capacity as it aged it should hold OK but there are several other bulbs pulling current thru the breaker that will also be on at the same time. If headlights start cycling off after a few minutes and then back on and then off again the circuit breaker on the headlight switch should be replaced with a new one. New 30 amp self resetting breakers of the same stud mount and connect type are available at most parts stores.
With the fairly long run of stock wiring and the heavier current going thru the headlight and dimmer switches that could dim the output a bit and stress the old switches. Some have added relays in the circuit to power the bulbs directly from the battery via a shorter but separate heavier gauge power wire and a dedicated headlight breaker. That helps to lower any light output loss and takes the stress out of the old breaker and switches and most of the old wire.
Attach file:
H6006.jpg (143.65 KB)
With the fairly long run of stock wiring and the heavier current going thru the headlight and dimmer switches that could dim the output a bit and stress the old switches. Some have added relays in the circuit to power the bulbs directly from the battery via a shorter but separate heavier gauge power wire and a dedicated headlight breaker. That helps to lower any light output loss and takes the stress out of the old breaker and switches and most of the old wire.
Attach file:
H6006.jpg (143.65 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=265731