Quote:
Joe wrote:
Digging into disassembly.
Been there done that!!!
How do your cylinder walls look? I think with the amount of build up you should pull your pan again and pull your pistons. You might have rings that are stuck, and rings are inexpensive, you could clean your pistons and throw a new set in. Might as well keep going down the rabbit hole! LOL
It would also allow you to check your wrist pin bushings, although I don't think your noise is a bad bushing, but engine noises are funny things. Might as well check your piston clearance as well. Mine were a bit loose so I had them coated.
By the time you're done she's going to purr like a kitten!
Keep posting updates!
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=266872