Re: Body Mounts
Posted by 53 Cavalier On 2024/3/10 19:06:52
Thanks again Howard!
Here's what I pulled out of the driver's side from front to back. (left to right in the picture)
Inner #3 & #4 have an empty space between floor pan brace and frame, I'm sure they are supposed to have a thick cushion like inner #2.
Now to gather up some parts!
For the most part it appears that the cushions kept everything sealed, so not much for rust where the cushions go. I can't really get in there to sandblast those surfaces, but I would like to clean them up and paint them before putting the body mounts back in. Open to suggestions!
Attach file:
20240310_164748.jpg (3,248.54 KB)
Here's what I pulled out of the driver's side from front to back. (left to right in the picture)
Inner #3 & #4 have an empty space between floor pan brace and frame, I'm sure they are supposed to have a thick cushion like inner #2.
Now to gather up some parts!
For the most part it appears that the cushions kept everything sealed, so not much for rust where the cushions go. I can't really get in there to sandblast those surfaces, but I would like to clean them up and paint them before putting the body mounts back in. Open to suggestions!
Attach file:
20240310_164748.jpg (3,248.54 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=268688