Re: LED brake light/turn signal bar

Posted by DavidPackard On 2024/3/21 15:21:32

Likely yes, there may be issues at 6 volts. I've been successful with single LEDs on 6 volts, but not arrays. I have been looking at optically isolated ICs that can switch up to 3A on the load side, with only 5-10 mA required on the 6 volt input side. See Panasonic AQV252G. The plan is/was to let the 6 volt bulb circuit trigger the IC thus completing the 12 volt side circuit. A simple 6+ to 12- converter would be used to power the LEDs.

dp