any ideas....

Posted by jsa03781 On 2010/8/9 7:38:15

My 1948 Custom eight is getting a new wiring harness. When I got the the junction block for the headlights and such I realized that I was going to need to order and new one. That arrived in a couple of days. So I continued the install of the harness. Yesterday I started to take the block off the drivers side fender and one nut came off nicely and the other one is turning but It is the bolt that is rotating I tried to feel the back side to see where it goes and I haven't got a clue how I going to get this off and then to install another one. Any ideas guys?