Re: Ultramatic Clutch Disc and Linkage questions

Posted by Mike On 2010/11/8 14:37:23

Waiting for the gauges to come in tomorrow (local harbor freight was out of them) so i'll put off completing the converter until tomorrow.

Got a dial indicator and stand so i can make a better measurement of the shaft thrust play. I had been putting getting one of those off, luckily the cams, etc i had installed weren't over spec.

No luck on finding the marks i made on the converter housing...must've cleaned them off. Can the whole assembly be balanced again and where would i look to have that done? Again i have a 50/50 chance of getting it right with the marks stained on the back side.

thanks again for all the help!