Re: Ultramatic Clutch Disc and Linkage questions

Posted by Mike On 2010/11/17 15:43:24

Ross was saying not to replace a bushing if it was within spec (.003 i believe) or otherwise you're not gaining anything by replacing it. For a moment i thought the spec was within .030, so my .009 would have been fine. Once i found out the clearance was withing .003 and i was three times the clearance, i thought i'd go ahead and change it. I'll have to stop at harbor freight, they had a blind hole bushing removal kit. I'll measure how far down in the "hole" the two bushings are, then pull them, then push the new ones back down in to the same depth.

The tranny itself is getting new bushings at the tranny shop, i'm just talking about the two next to each other in the blind hole at the far "Front" of the converter, where the tranny input shaft end rides.