Re: Ultramatic Clutch Disc and Linkage questions

Posted by Mike On 2010/11/17 18:33:17

If i could get a set of ultramatic tools, i'd snap them up in an instant. the bore gauges that were on ebay, whatever is needed to hook up the gauges in the car so you can drive and test, the bushing installers. I'd only use them once or twice, but i'd have a complete set to loan out to others and know that they're here if i need them.

Unfortunately they seem super rare :(

I'll make sure that a) the bushings are the same height and b) how deep in the hole they are before removing, then install them bottom one first and should be set to go. they both look to be the same bushing.