Re: 1st time startup

Posted by PackardV8 On 2010/12/1 20:33:29

Remove the spark plugs. I assume they're 14mm and not the tiny 10mm. Look down into the spak plug hole. Most flat head engines run the spark plug somewhat directly over the exh valve. If an exh valve is hanging open then use a brass drift and a small hammer to JUDICOUSLY drive the valve down a little ata time while working it back up by cranking the engine crank back and forth.

DO not use alot of force. Work at it slowly and get the valve moving a little at a time. Keep snake oil on it.

THis mite save a lot of work and gaskets. If the intakes a re stuck then u're stuck.