Re: Rear quarter panel trim removal
Posted by Owen_Dyneto On 2011/2/20 12:53:19
Here's a wrench I made some years back for the antenna nuts. Simple to make, just a piece of 1/4 square aluminum stock, bent in an appropriate half-circle, and drilled for a hardened steel pin. Should take about 30 minutes to make one, if you're so inclined.
Attach file:
(38.56 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=71234