Re: rear axle seal

Posted by walkerman On 2011/5/5 19:13:19

Well I would like to thank everyone for the help.I finished the axle seals today and after doing it . it was very easy. I did find the shims there were 6 on the left side non on the right side. I must say everyone schould do this the bearings did need to be packed not much grease in them at all.When I saw the tool I was able to use a puller I made. I put a hole in the middle of 3/8 bar then weldr two 1/2 nuts on each side. welded 1/2 nuts to some all thread to use as a axle puller. the right side came right out the other side I needed the puller. Then I took one of the all threads out and used it to check gap I was about 8.

The inner seal was a National-49184 a lot thicker then the new one.national # no good

The outer seal was C/R 22382-I used the same. Someone must have put new outer seals and not inner

Bearing is Bower 26878
Race is Tyson 26820

Thanks Again