Re: Clipper Custom Rear Courtesy Lights

Posted by BigKev On 2011/5/16 12:21:42

JW,

Usually switches are on the ground leg. Use a test light or multimeter meter and see if you have power between the each one of the socket legs and a piece of body metal. If you get a reading on one of the legs that is good. Now check between the other leg, and ground do a continuity check with the pillar/door switch on. If it doesn't check out ok, then you have either a either a bad ground at the switch, a bad switch, or a broken wire between the switch and the bulb socket.