Attached are the pics of the main cap and the bearings...pretty marked up, and one edge is even kind of sharp and peeling metal off! Don't know if that's a thrust issue or not.
Trying to read the markings on the back but no luck yet, so can't see if they're standard size or not. I see someone has stamped the mains 1,2,3,4,5...etc so the bottom end has been apart at some point.
Any suggestions before i just throw another bearing in and plastigauge it?
Also, the cap has a notch in the edge for locating a bearing, but i don't see any locating notches on the bearing.
Attach file:
(79.11 KB) (97.59 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=81391