Re: 1950 Packard -- Need Help RE Overdrive Cable Installation

Posted by HH56 On 2011/9/15 22:15:05
Until a real picture of a 23rd series comes along, here is the R9 cable setup from the 22nd. The R11 used the same cable and a similar arrangement but since it was on the opposite side of OD may have been a mirror image.

The R9 to R11 upgrade kit instructions said to flip the rear engine support end for end to move the cable to the left side and install it in a new clamp. Look on the drivers side of rear engine support for a couple of holes where a bracket might go. Not sure whether it was vertical like the R9 or just flat piece for bottom of U bolt. There were other clamps and I added the instructions on where they were attached to the cable illustration. No illustrations on those extra clamps so someone will have to provide a picture.

Attach file:



jpg  (30.80 KB)
209_4e72bf0df2c68.jpg 642X487 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=86119