Re: Disc Brake Bolt-On???

Posted by BigKev On 2007/2/16 22:26:19

Well Craig's setup (or at least one of his setups) did require the machining of the original knuckle to to provide clearance for the disc, and also the spindle machined. Perhaps is a disc was found rode farther out on the spindle, then it might not have the clearance issue.

I always thought the best solution would be to create an entire new setup that had new upper and lower control arms that bolted in the stock location that used ball joints and a new steering knuckle that maintained the correct alignment and placement and uses the stock tie rod. This is perhaps a pipe-dream. But that has got to be easier that doing a subframe swap or something like that.

So that why I thought if you could just get a new steering knuckle designed, that would be they easiest solution.