Re: treadle vac master cylinder

Posted by HH56 On 2011/10/10 16:36:44

I don't recall that notch being there but it's been awhile so others can better answer. The whole sealing area looks rough though so if that is part of a seal surface for the cup, would wonder.

One thing I am curious about is your rebuild kit. If new, what kind of cover gasket or instructions did you get with it. There was an issue we found with gaskets covering the relief port on later units. Some problems result if that happens because of the Packard cover not being for the gaskets they were sending. Some history starting about here:https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=61166#forumpost61166 Was wondering what the vendors are doing now -- shipping the same gasket & advising to rotate it, cutting it or what.