Re: bushings for shift idler lever?
Posted by HH56 On 2012/1/22 17:00:39
Quote:
Here's a photo of some from a 47 which are the same as ones being asked about--although not sure these are the specific ones needed. There were different part numbers for various locations but not sure what details changed without study.
These are steel and have a slight rounded contour with the clearance ridge on each side. Very early ones were a rubber compound but was apparently a quick wear item so were replaced with the steel.
Attach file:
(15.53 KB)
BlackBeerd wrote:
Are those plastic flange bushings?
Can somebody post a picture?
Here's a photo of some from a 47 which are the same as ones being asked about--although not sure these are the specific ones needed. There were different part numbers for various locations but not sure what details changed without study.
These are steel and have a slight rounded contour with the clearance ridge on each side. Very early ones were a rubber compound but was apparently a quick wear item so were replaced with the steel.
Attach file:
(15.53 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=93377