Oil Filter Lines
Posted by BigKev On 2008/4/6 18:22:23
Ok can someone check something for me. I have this picture of oil line routing from an earlier motor (there is no picture of the line routing for the 51-54 motors in the service manual or part plates).
If you follow the oil filter lines (as I am reading it), it appears it comes from the pressure sender "T" and then goes to inlet on the side of the filter, and then the output (on the bottom) or the filter drains back in to the pan via a block fitting above the pan.
But on my filter (which is a Packard labeled filter), the fitting on the bottom is stamped "Inlet" and the one on the side is stamped "Output". So this picture is confusing me as it appears backward to how my filter is labeled. My filter was no plumbed correctly to start with. So can some take a picture of their 51-54 and let me know how it was originally plumbed.
Thanks,
Attach file:
(23.74 KB)
(17.58 KB)
(16.88 KB)
(19.96 KB)
If you follow the oil filter lines (as I am reading it), it appears it comes from the pressure sender "T" and then goes to inlet on the side of the filter, and then the output (on the bottom) or the filter drains back in to the pan via a block fitting above the pan.
But on my filter (which is a Packard labeled filter), the fitting on the bottom is stamped "Inlet" and the one on the side is stamped "Output". So this picture is confusing me as it appears backward to how my filter is labeled. My filter was no plumbed correctly to start with. So can some take a picture of their 51-54 and let me know how it was originally plumbed.
Thanks,
Attach file:
(23.74 KB) (17.58 KB) (16.88 KB) (19.96 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=6546