Re: Oil Filter Lines

Posted by JD in KC On 2008/4/7 9:08:42

I'd be interested to see the outcome of this. I recently installed a used canister from Kanter which did not have inlet/output engraved on it. I used the same engine illustration you have above to figure out where the oil lines went. It seemed logical to me that the oil flow would be from the outside of the filter (side fitting) to the restricted flow tube running up the center of the canister and then back out to the engine (bottom fitting). Anyway that's how I interpreted the illustration for my '50 356 custom. If my canister had been labeled as yours is... I would have been equally baffled.