Re: noisy lifters (hydraulic)

Posted by fory On 2013/6/9 16:59:01

Here's the pics of my oil filter I didn't post before. Anyways, you can see there's three fittings on it, one on the bottom off the the side, one of the bottom that goes up into the center post, and one on the side. The center post has a hole, less than 1/16" drilled through it (effectively two holes, I suppose. One on each side). I'm thinking oil goes IN the bottom/post fitting, and OUT either of the other fittings... Would it matter which is the out, or just whichever one is convenient? Because of the very small inlet holes, do I still need a restriction in the fitting?

Attach file:

---

  (149.25 KB)


  (73.51 KB)