Re: noisy lifters (hydraulic)

Posted by HH56 On 2012/3/7 23:20:08

The oil gallery feed is on the driver side. There should be a short U shaped pigtail between a tee like fitting on bottom where the oil sender is. The gallery feed is just above it to supply oil to the lifters. One side of tee would go to factory oil filter (if you have one) and other side of tee goes to gallery. Sender is in the middle. There is supposed to be a restriction in the fitting on the side that goes to filter. Make sure the pigtail is present, open, and the restriction goes to the filter not the gallery.

Attach file:

---

  (17.74 KB)