Re: Water pump/Engine mount
Posted by Joseph Earl On 2012/3/25 15:04:29
Owen and Wesley,
You are confirming what I figured that I would have to do. Good hint on the exhaust pipe- I can see where that might be a hindrance.
I have jacked engines before at the dampener, but unfortunately the Packard does not allow access to it from below. The U-2 X 4 configuration may be a possible solution, but before I take the time to construct that I will try a large block under the front of the pan. Simple sounds better.
I have to pull my pan too, so eventually I may build a device to get around the crossmember.
Thank y'all!
Attach file:
(45.66 KB) (56.63 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=97428