Re: Water pump/Engine mount

Posted by Owen_Dyneto On 2012/3/26 9:27:13
When you reassemble, first check the pump body bolts for proper clearance length, those that are nearer the center of the block may be shorter because of the proximity of the cylinder wall. Also, they are threaded into the water jacket so gasket shellac or Permatex on the threads is necessary. Also, check to see if one or more of the pump bolts uses a flat copper washer beneath the head - if so there may be a flat recess in the pump casting.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=97487