Re: Water pump/Engine mount
Posted by Joseph Earl On 2012/3/26 21:48:02
Ross,
That is the measurement I came up with after pulling one.
I used the screw/pry bar technique with a piece of 1/2" plywood under the fulcrum for leverage and to protect the block. I had to use a chisel to loosen the lip a little and they popped right out.
Attach file:
(55.57 KB)
(61.18 KB)
That is the measurement I came up with after pulling one.
I used the screw/pry bar technique with a piece of 1/2" plywood under the fulcrum for leverage and to protect the block. I had to use a chisel to loosen the lip a little and they popped right out.
Attach file:
(55.57 KB)
(61.18 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=97575