Re: Speedo cable help needed

Posted by BDeB On 2012/6/23 17:09:07

Best bet would be to feed the new cable through from the top end with the drive gear in place until it bottoms out at the transmission end. The socket in the drive gear is almost 1" deep, so the squared end of the cable should stop it before it hits bottom in the drive gear. Subtract about 1/8" for expansion and mark the cable at the top end so that the new tip will extend about 1/2" past the end of the housing.

Edit: That's assuming you can get the remnants of the first replacement cable out of the housing.
Good luck!