Re: 1954 ultra selector shaft seal
Posted by HH56 On 2012/7/9 8:40:48
The old seal comes out easy enough however to install the new seal is a bit more tricky as you will need to fabricate a tool that will fit over the selector shaft and contact the face of the new seal, then you will need to use something like a flat bar with a bend in it to pry against the frame of the car to "press" the new seal back in.
If the hole is there and lines up, this is what was recommended on the twin Ultra. 55 seal was the same as earlier and I think shaft is close to same length so might work on yours. Use an extension to get extra length thru the hole.
Attach file:
(16.55 KB)
If the hole is there and lines up, this is what was recommended on the twin Ultra. 55 seal was the same as earlier and I think shaft is close to same length so might work on yours. Use an extension to get extra length thru the hole.
Attach file:
(16.55 KB)This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=105112