Re: Aftermarket Rocker Panels

Posted by 55 NC Clipper On 2012/8/8 12:53:58

I purchased the rockers and was very unhappy with them. They do not have the same curve as the front doglegs or the rear quarter. They height was wrong too, when I cut out the existing rocker and then put it in, the flanged underside was about 2" below where the rocker previously had stopped, so I had to cut a 2" 20 gauge strip, weld it on to the purchased rocker to make up the gap.

I know they were for 400's and senior models, but I didn't think there was going to be that much of a difference.