Re: Torsion Level Problem

Posted by Jed Sheehan On 2012/8/18 10:41:59

Finally, success!

The shop replaced the front control arm bushings and that seems to have fixed the problem. They also report that the bushings were in very bad condition and look like they've never been replaced.

So, either I mistakenly thought the kit I bought from Kanter 10 or 12 yars ago included the control arm bushings or the shop never installed them. I haven't found the paperwork on the kit yet but I don't think the kit included those bushings. The control arm bushings alone were much more expensive than the entire front end kit I bought from Kanter.

The good news is that I have a completely new or rebuilt T-L system, and every part I replaced needed replacing. The bad news is it wasn't cheap! Oh well, it needed to be done.

Thanks for everyone's advice on this problem. And for everyone with a T-L system, if it's see-sawing on you and there's no resistance in the system, check those control arm bushings!