Re: Factory AC and glovebox.

Posted by PackardV8 On 2012/9/18 11:10:19

THanks for the explanation.
AS for the original question in post #1 above i'm wondering if a telescoping glove box liner would do the trick. Need 2wo OEm glove box liners. Cut one about 5/8 short from the back side. CUt the other about 5/8 short from the front side. i.e. take 2wo box liners cut in "half" so that the back 'half' slides over the front 'half' about a 2 inches.

put a couple xcrews or plastic trim button retainers to hold them together at the final fit dimension.

To remove liner: remove screws slide the liner halves together like a telescope makeing it much narrower and slide the assembly out of the dash.