Re: T-L Front upper control arm bushings R&R
Posted by HH56 On 2013/4/21 9:07:55
So begs the question. Should there be washers behind the bushings or not. I can't tell on mine but if they are present, the OD is not as large as Riki's. If there are washers present, why would a spacer act any differently. Obviously right or wrong, his arm gained a set sometime in it's lifetime.
The parts manual lists 5/8 nuts and washers which I could think might be for holding the large outer cupped washer at the end of bushing and shaft. It also lists 3/4 washers but doesn't show enough detail to see where they go.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=121405