Re: Kent Moore vibration damper remover & replacer tool
Posted by HH56 On 2013/5/9 21:23:16
Quote:
Let the ride decide wrote:
Here is mine,on the red towel,
and then the one sold on e-bay
mine has the corner braces cut. Should I try to add them back? How would you do that?
If your tool is a steel forging I'd think a welding shop could cut triangles and attach them. Maybe they could heat and straighten the bends and then weld in one or two reinforcements. Looking at the 55 SM It looks as if there is a small space available for a reinforcement before it would hit the outer diameter. Maybe you could slide it on and get a rough measurement of how big it could be. Perhaps two on each side at the very outside edges. If the tool is cast then I have no suggestions.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=122785