Re: Re-Setting Torsion Ride

Posted by R H On 2013/8/12 7:53:27
bill,

you can power the motor,

turn off switch, or pull the fuse ,,purple wire, ans main body fuse, big red wire, on driver side fender,

on the motor, the terminal, one goes up the other down,

run a jumper wire from the battery, instead of pulling fuses, you also can disconnect the battery ..

with the wire wire, jumper cables,, one to ground, the other to to post, see which way it goes,

if you can lower rear, then like howard said adjust the rod, you can can loosen that rod, and make it go up and down thru the compensator switch. with that you keep battery hooked up.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=129081