Re: Re-Setting Torsion Ride

Posted by 55 NC Clipper On 2013/8/12 11:44:18

So, I have a question. People talk about overtravel and I have seen bent motor gears, I thought there was a cutoff bar that prevented this? Was it broke in those cases?

Second question, if let go will the torsion ride go as far down or up as it wants until pressure builds up and then it can go no more or break? or is there acutally a limit of just persay 4" travel up and 4" travel down (made up numbers) for the front and rear?

Thanks

I am just trying to figure this out.