Re: One oil pump modification now on file

Posted by R H On 2013/10/29 22:48:19

OD, Jim, Jack,,

thanks,

my plan was to go as high as i could in block,,so it is being done.

that bushing is PC 780.. around 10 dollars. i am going to make a longer sleeve to give upper shaft more support. i'll give shaft a few thou of movement

also with the PI pump, since they pushed shaft down, that means there is less up in the dist. drive gear.

once i get into this i will take pictures. i was going to make a one piece drive shaft with a step to replace sleeve.

so i need to look for cast iron,,bronze is easier to machine. bronze i have.

also going to have that PI plate re surfaced. should toss it. the bushing there will help keep the shaft in alignment.

thanks again everyone.