Re: 55 Torsion ride pin

Posted by Owen_Dyneto On 2013/10/31 10:43:30

Never worked on a 55 pin but the 56 pins are duck soup to take apart - the end caps are just pressed into a hole in the pin. Secure the pin or the cap and just rotate with a little force and pull out. If you want longer pins, just get a suitable length of good, high quality steel like hardened drill rod, drill the holes in the ends and press the end caps back in.

Note that there is a limit to how long a pin you can use before you throw the front end geometry off. I'd also recommend a front end alignment check after changing pin length.