Torsion Ride Pin

Posted by 55 NC Clipper On 2013/12/8 17:39:34

A little while ago I had posted a few questions on removing the pin to re-level the car. I took the pin out again today and further inspection of the base on the lower control arm. The retainer seat on the lower control arm has a 3/8" high wall, about 1" of this wall has rusted away, the rest of the wall is fine.

Also, pictures have shown that this pin can be taken apart but I tried and there is no movement of either end. I used a hammer to try to hit it apart but no luck. Next, is torch, but I wanted to make sure that it is for positive removable at both top and bottom.
Thanks

bill

I also have pictures but cannot upload them on the computer, they are on my email.