Re: V8 pistons

Posted by BH On 2014/1/3 18:09:14

You'll find application listings in the parts book for export applications. However, except for the speedo head being available in KPH for 55 and 56, they're not very clear or consistent.

For example, there are Canadian/export listings for shocks on 55th Series models; STB 55T-42 also recommends these same units for heavy-duty use (in domestic applications). However, while 56th Series shows heavy-duty shocks, there's no mention of Canadian or export.

Meanwhile, H-D torsion bars are shown for 56th Series only, with no mentions of export.

The only mention of low compression (ratio) equipment that I found was shims for both cylinder head AND intake manifold, but without specific mention of Canadian or export use.

There's an export tool shown for both for 55 and 56, but is that part of 'Special Export Equipement' and all that the package includes?

I could add the aforementioned export codes to the end of the 56th Series chart and ask BigKev to post another revised PDF, but I'd hate to back same codes into the 55th Series chart without additional, supporting documentation of that year.

I'm open to creating/revising such charts for prior years/Series, as well - provided somebody comes up the bona fide docuements.