Re: 55 control arm bearings

Posted by PackardV8 On 2008/10/15 21:07:55

Then what's needed for my 56 Exec. ????

When the rear of the car is setting with the bottom of the fender skirt 1/4 inch above centre of the red Hex in the wheel cover then the front of the car is setting low by about 3/4 inch and there is 1 to 1-1/4 inch ride control at the front suspension rubber snubbers.

The car has a 4 ringer on the right side and a 2 ringer on the left side. AC pump on left side. 75 pounds of routine junk i need to carry anyway in the trunk and situated to keep car transversly level.

4 ringer is the longest packard made???? I already have a 4 ringer on the right side. If i put a 4 ringer on the left side then that side will go up leaving the right side low????