Re: 56 400 headliner
Posted by HH56 On 2015/2/1 10:56:01
I don't believe it is the same. IIRC, that upper door piece is wide, maybe L shaped stainless with a rolled over bottom edge. The inside chrome edge of window pushes against the L and some fuzz. I believe the fuzz is glued to the side of the L with bottom edge set into the rolled over portion so the window can't catch the edge of fuzz and pull it off.
If the construction is as I think, possibly you could use a Dremel with a small diameter cutoff wheel to remove the old fuzz and open a slot at the rear of the rolled edge at the same time. Restoration Specialties has a normal height but very thin with almost non existent beading belt molding where one edge might be able to be inserted in the slot and the body of the belt molding reglued to the Packard piece.. Whether you can open the rolled portion to extract the old fuzz and insert new without visible dings or damage is the question.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=156858