Re: Monroe Power Steering Actuator Service Manual

Posted by Packard 1948 On 2015/9/7 16:19:34

Thanks Randy and Howard. I was able to find what I needed on page 29.

So it looks like the power steering pump I have is a Eaton 5H pump.

I built up a power steering pressure tester with a ball shut off valve and a pressure gauge. When the valve is fully closed the pressure will build to only 660 PSI which is the design pressure as per the Chrysler manual and it is also the same pressure prescribed by the Bendix system.

Hmmm...so now it looks like I will make a call to Lares and see if they can increase the pressure output of this pump.

THANKS AGAIN!!!