Re: Push Button Relay Water Trough

Posted by Owen_Dyneto On 2016/4/14 11:37:08

Unless someone beats me to it I'll get out in the garage this afternoon and get the measurements for you. I can't confirm the original color or finish, mine was painted over when the car was repainted.

EDIT: A simple "L' (right angle) shaped stamping. The base to fit full width in the fender trough; inboard riser height 1 inch; length 20-1/2 inch. Location starts 1/2 inch forward of the rear-most hood bumper rubber, thus it ends about 1-1/2 inches from the middle hood bumper rubber.