Re: Caribbean top boot

Posted by HH56 On 2017/6/25 21:44:49

Since it retracts when disconnected I would wonder about the cylinders too. In addition to being the same type are there any center to center differences in length between the rod end clevis that connects to the top and the pin at the base mount when fully retracted. Is there any side to side offset at the base so that as the rod end gets near the cylinder and nothing can flex is it off parallel a tiny amount and forcing a bind at the rod clevis to top connection. Also, is the front to back mount position exactly the same so both cylinders are at exactly the same angle (and effective length) to the floor when retracted.