Re: Rekeying replacement trunk lock cylinder

Posted by JeffM On 2009/1/5 19:47:26

Okay, I'm installing, and the C-clip that holds the lock linkage to the tailpiece of the cylinder is not going on tight at all. You can snap it on and remove it by hand with very little effort. I am afraid that just closing the trunk could pop the clip off and then, I'd be locked out.

I had this problem previously and just sort-of overlooked it. I bought new clips in a clip assortment pack at the auto parts store. Every single one goes on loosely. There were 3 or 4 of this same size.

And since the clips are made of high-tensile steel, you can't just bend them to make them tighter. They tend to warp and/or break if you try to use pliers to close them for a tighter fit.

Any suggestions? I'm still thinking....